Hot Tub Water Treatment / Hot Tub Cleaners

<< Back

Ahh-some hot tub & jetted bath plumbing & jet cleaner 6oz
$79.99
Brand: Ahhsome

You can save this product on your favorites list when logged in to your account. Login now

Description

JUMBO SIZE!

Dislodges and removes buildup and biofilm from hot tub / spa or indoor jetted bathtub plumbing and jets.

Hot Tub / Spa Use:

1. Adjust water chemistry to proper balance. Add additional sanitizer before purging. Ideally add to WARM or HOT water.

2. Remove all pillows and headrests if removable.

3. Add 1 level teaspoon of Ahh-Some per 100 gallons of water, directly into water.

4. Remove filter(s) from hot tub filter well. Hose them off. Place them into the hot tub.

5. Run the pump(s) and blower to attain maximum circulation. Be sure to open air intake valve(s). Note: Foaming will occur soon after pumps are turned on. This is Normal.

6. If Foaming is excessive, turn pump(s) off for a few minutes. Turn on again soon after.

7. Run the jets and blower (if equipped) for 20-30 minutes opening ALL jets and waterfalls.

8. Shut the system down. Wipe away clinging gunk and grime from shell with towel.

9. Drain the tub. Be sure to dump as much of the dirty water as possible. It is Ok to drain on the ground, in flower gardens or grass. Do NOT drain into lakes or a stream.

10. Remove the filter(s) from the hot tub and hose clean. Rinse the tub with fresh water.

11. Use rubber gloves and a good cleaner while rinsing and wiping the shell.

12. Mix 1/8th of a level teaspoon of Ahh-Some with 32 ounces of water in a trigger spray bottle to make a wonderful cleaner for the acrylic shell wipe-down.

13. Wipe the hot tub as clean as possible, getting the sticky gunk off the interior finish.

14. Fill the hot tub with water to proper level; replace filter(s) into filter well. Balance water and add proper sanitizer. Be sure to use a reliable test kit for proper chemistry.

15. Repeat every 4-6 months or as needed.

16.Some hot tubs / spas may need consecutive and additional purges.

Indoor Jetted Bath Tub Use:

1. Fill tub just above jets.

2. Open air intake control.

3. Add 1 level teaspoon of Ahh-Some per 100 gallons of water, directly into water.

4. Run pump for 30 minutes.

5. Drain, rinse and wipe tub surface clean.

6. Refill tub and run jets for at least one minute to flush completely.

7. Multiple applications may be required in certain tubs with large buildup.

8. Use Ahh-Some gel every 2 weeks or as needed.

Made in the USA

Alberta's Online Pool and Spa, Hot Tub and Swim Spa Equipment and Supply Superstore!